We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
The general purpose two-wire ultrasonic transmitter provides non-contact level measurement up to 32' or 10m, and is ideally suited for challenging ultrapure, corrosive or waste liquids. The general purpose ultrasonic level transmitter provides continuous level measurement up to 32.8' (10m) with a 4-20 mA signal output, and is configured via its integral push button display module. This non-contact liquid level sensor is ideally suited for corrosive, ultrapure, sticky or dirty liquids, and is broadly selected for bulk storage, day tank, lift station and process tank level applications.
Calibration is fast and simple with our scrolling single layer menu, three button interface and 6-segment LCD display. Troubleshooting is easy with our unique Setup and Diagnostic feedback modes. Setup displays the transmitter's calibration set points. Diagnostics provides users with a snapshot of sensor performance and application variables. Its full feature level made simple.
Range: | LU80: 4” to 9.8’ (10cm to 3m) LU81: 8” to 18.0’ (20cm to 5.5m) LU83: 8” to 26.2’ (20cm to 8m) LU84: 12” to 32.8’ (30cm to 10m) |
Accuracy: | ± 0.2% of range |
Resolution: | LU80: 0.019” (0.5mm) LU81/83: 0.039” (1mm) LU84: 0.078” (2mm) |
Dead band: | LU80: 4” (10cm) LU81/83: 8” (20cm) LU84: 12” (30cm) |
Beam width: | LU80: 2” (5cm) LU81/83/84: 3” (7.6cm) |
Configuration: | Push button |
Memory: | Non-volatile |
Display type: | LCD, 6-digit |
Display units: | Inch, cm and percent |
Supply voltage: | 12-28 VDC |
Loop resist.: | 500 Ohms @ 24 VDC |
Signal output: | 4-20 mA, two-wire |
Signal invert: | 4-20 mA, 20-4 mA |
Signal fail-safe: | 4mA, 20mA, 21mA, 22mA or hold last |
Process temp.: | F: -7° to 140° C: -20° to 60° |
Temp. comp.: | Automatic |
Ambient temp.: | F: -40° to 160° C: -40° to 71° |
Pressure: | MWP = 30 psi (2 bar) |
Enclosure rating: | NEMA 4X (IP65) |
Encl. material: | Polycarbonate |
Encl. hardware: | Brass & stainless |
Enclosure vent: | Water tight membrane |
Conduit entrance: | Dual, 1/2” NPT |
Trans. material: | PVDF |
Process mount: | LU80: 1” NPT (1” G) LU81/83/84: 2” NPT (2” G) |
Mount gasket: | Viton® |
Classification: | General purpose |
Compliance: | CE, RoHS |
Calibration
Calibration is fast and simple with our scrolling single layer menu, three button interface and 6-segment LCD display. Troubleshooting is easy with our unique Setup and Diagnostic feedback modes. Setup displays the transmitter's calibration set points. Diagnostics provides users with a snapshot of sensor performance and application variables. Its full feature level made simple.