We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
MN307 is designed for low AC current measurements up to 10A, it offers a higher voltage output of 100mV per Amp (1VAC @ 10AAC) for enhanced sensitivity at lower levels, while offering a high crest factor at full range. The MN307 has an integral 5 ft (1.5m) lead terminated by shrouded banana plugs.
Electrical | |
Nominal Range | 10A |
Measurement Range | 0.01 to 12A |
Transformation Ratio | Voltage output |
Output Signal | 100mV/A (1V @ 10A) |
Accuracy (10A Range) | |
0.1 to 0.5A | ≤2.5% of Reading ± 0.1mV |
0.5 to 1A | ≤2.5% of Reading |
1 to 12A | ≤1.0% of Reading |
Phase Shift (10A Range) | |
0.01 to 0.1A | Not Specified |
0.1 to 1A | ≤5.0° |
1 to 5A | ≤3.0° |
5 to 12A | ≤2.5° |
Overload | 12A for Continuous |
Frequency Range | 40 to 10kHz |
Limit Operating Conditions | 200A permanently to 3kHz; Derating above 3kHz: 200A x (1/0.333F), F in kHz |
Crest Factor | 3 @ 10Arms with an error (due to CF) of 3% |
Working/Common Mode Voltage | 600Vrms |
Output Termination | 5 ft Lead |
Mechanical | |
Operating Temperature | 14° to 131°F (-10° to 55°C) |
Storage Temperature | -40° to 158°F (-40° to 70°C) |
Operating Relative Humidity | 10 to 35°C 85% RH (without roll-off above 35°C) |
Jaw Opening | 0.83" (21mm) |
Maximum Conductor Size | 0.78" (20mm) |
Dimensions | 5.47 x 2.00 x 1.18" (139 x 51 x 30mm) |
Weight | 6.5 oz (180g) |
Polycarbonate Material | Polycarbonate with fiberglass charge, UL94 V0 |
Safety | |
Electrical | EN 61010-2-32 |
UL Approval | Yes – Canada and United States |
Double Insulation | Yes |
CE Mark | Yes |
Note: Reference conditions: 20 to 26°C, 20 to 75% RH, external magnetic field <40A/m, 48 to 65Hz sine wave, distortion factor less than 1%, no DC component, no external current carrying conductor, test sample centered. Load impedance >1mΩ
Write Your Own Review